|
Kevin, Amsoil has long offered a remote
filter system, complete with proper hoses and fittings. You can plumb in
directly or they provide an adaapter that fits the factory mount, quite
flush. Also,
their oil filter stands above all others, it has a
new nano=-fiber echnology that will filter down to uner5 microns, and not
restrict oil flow. Extended oil dreain is possible with the usee of their
best oil and
this filter.. Duane Service
----- Original Message -----
Sent: Wednesday, May 06, 2009 4:00
PM
Subject: [FlyRotary] remote oil
filter
my renesis
engine only came with 2 holes and 2 studs in the block for the filter. i
was going to install a remote since i doubt the stock will fit under a rv-6a
cowl. since the holes are close together it seems i should have the
threaded ports come out on opposite sides. from there i would need flex
lines with/without 90's to the remote filter base. i think i need a port
for the redrive too. is it acceptable to mount the remote on the
redrive plate? is there a better place? the cool side of the
engine seems will be busy with plug wires and cooling ducting. is
anyone selling this part or have a drawing i could use to have one made?
other than the O-ring seats, it seems the whole thing could be done on a
drill press with std bits and taps, no? are the seats machined flat and
square, or filleted the dia of the O-ring? kevin
No virus found in this incoming message.
Checked by AVG -
www.avg.com
Version: 8.5.320 / Virus Database: 270.12.19/2099 - Release
Date: 05/05/09 13:07:00
|