|
|
| Steve, that's why I'm asking the experts on this. I'm still trying to figure this out. The older 13b OMP has 4 ports. So did the 20B OMP, with only three lines. I was planning on not using the 4th port. Where does the 4th line go to on the 13b setup?
Mark On Sun, Apr 8, 2012 at 8:29 PM, Steven W. Boese <SBoese@uwyo.edu> wrote:
Mark,
Since the OMP 's I've seen are set up with 4 oil lines and intended for a two rotor engine, how do you intend to adapt it to the three rotor engine in terms of amount of oil metered and how it is distributed?
Steve
From:
Mark Steitle
Sent: Saturday, April 07, 2012 8:10 PM
Subject: [FlyRotary] OMP Plumbing
Is anyone running an oil metering pump (OMP) that can help me figure out how the lines should be connected. I'm planning on using the Mazda banjo fittings to hook up to the OMP, but what do I do with the check valves. Do you connect the check valves to a
vacuum source or just block them off? Will the system work properly if I plug the check valves? I plan on locking the lever in the full open position. Will this work for a/c use? I'll be using Richard Sohn's adapter with a 1 gallon reservoir filled with
2-stroke oil.
Mark S.
|
|