Thought the group would like to hear what i found when I Finally had a chance to closely examine Bill's EC2.   I was hoping to find a definitive reason behind his sudden and complete loss of power on takeoff on his last flight.

On powering it up on the bench I found both A and B controllers Working normally.   Bill noted in his report that in the 'Fly The Plane' situation  called for in a power failure during takeoff he had not tried switching to controller B.  It does not appear that it would have done any good this time.

None of the parameters were set outside the expected range so no sign of data corruption.  In fact the only thing notable about the data downloaded from it was the unusually smooth programming of the MAP table.  Most of the time I find units returned for updates with choppy looking data in the table indicating a lack of care or proper methodology in setting it up.  A and B controllers had identical data.

The PCM was also returned with the unit so just in case the control panel was the cause I substituted it for the bench test panel I normally use.   Thought I saw a problem because the injection pulse width was so large that it could well have caused engine flooding.  This was caused by the mixture control being set fairly high and the cold start switch being in the on position.  This does not prove anything because that could easily have happened during removal of the panel from the plane or while packing it for shipping.  When the switch and mixture control was returned to normal settings the injection pulse width returned to normal.

Ran the unit on the bench for several hours while heating and subjecting it to vibration but nothing else turned up.

Tracy
--
Homepage:  http://www.flyrotary.com/
Archive and UnSub:   http://mail.lancaironline.net:81/lists/flyrotary/List.html