I found a wrecking yard here in Florida that claims to have 150 RX-7s in it.
I haven't counted, but I suspect that may be a little on the high side. But
there are a lot of them. If anyone is interested, I will get the contact
info for the yard. They are located in Sanford, Florida.
Bill B
-----Original Message-----
From: Rotary motors in aircraft [mailto:flyrotary@lancaironline.net] On
Behalf Of Bob White
Sent: Tuesday, February 05, 2008 8:43 PM
To: Rotary motors in aircraft
Subject: [FlyRotary] Re: Flex plate
I'm going to need a flywheel from an 89 or up NA to match my 9.7:1 rotors.
Anyone have one available?
Thanks,
Bob W.
On Wed, 06 Feb 2008 01:01:46 +0000
"Kelly Troyer" <keltro@att.net> wrote:
> Joe,
> A 3rd gen counterweight and flex plate will fit 2nd gen 13B but the
> counterweight will put the 2nd gen out of balance unless rotors and
> both counterweights from the 3rd gen are installed also...........On
> another note if this engine is for an A/C using Tracy's redrive you
> must use a 2nd gen flexplate........FWIW
> --
> Kelly Troyer
> "Dyke Delta"_13B ROTARY Engine
> "RWS"_RD1C/EC2/EM2
> "Mistral"_Backplate/Oil Manifold
>
>
>
>
>
>
> -------------- Original message from "Joe Berki"
> <jskmberki@alltel.net>: --------------
>
>
> Will a flex plate and counterweight from a 3rd gen 13b fit a 2nd gen 13b?
How much for a flex plate and counterweight? Thanks for any help.
>
> Joe berki
> Limo EZ
--
N93BD - Rotary Powered BD-4 - http://www.bob-white.com
3.8 Hours Total Time and holding
Cables for your rotary installation - http://roblinstores.com/cables/
--
Homepage: http://www.flyrotary.com/
Archive and UnSub:
http://mail.lancaironline.net:81/lists/flyrotary/List.html
--
Homepage: http://www.flyrotary.com/
Archive and UnSub: http://mail.lancaironline.net:81/lists/flyrotary/List.html