|
|
I found a wrecking yard here in Florida that claims to have 150 RX-7s in it.
I haven't counted, but I suspect that may be a little on the high side. But
there are a lot of them. If anyone is interested, I will get the contact
info for the yard. They are located in Sanford, Florida.
Bill B -----Original Message-----
From: Rotary motors in aircraft [mailto:flyrotary@lancaironline.net] On
Behalf Of Bob White
Sent: Tuesday, February 05, 2008 8:43 PM
To: Rotary motors in aircraft
Subject: [FlyRotary] Re: Flex plate
I'm going to need a flywheel from an 89 or up NA to match my 9.7:1 rotors.
Anyone have one available?
Thanks,
Bob W.
On Wed, 06 Feb 2008 01:01:46 +0000
"Kelly Troyer" <keltro@att.net> wrote:
Joe,
A 3rd gen counterweight and flex plate will fit 2nd gen 13B but the counterweight will put the 2nd gen out of balance unless rotors and both counterweights from the 3rd gen are installed also...........On another note if this engine is for an A/C using Tracy's redrive you must use a 2nd gen flexplate........FWIW
--
Kelly Troyer
"Dyke Delta"_13B ROTARY Engine
"RWS"_RD1C/EC2/EM2
"Mistral"_Backplate/Oil Manifold
-------------- Original message from "Joe Berki" <jskmberki@alltel.net>: --------------
Will a flex plate and counterweight from a 3rd gen 13b fit a 2nd gen 13b?
How much for a flex plate and counterweight? Thanks for any help.
Joe berki
Limo EZ
--
N93BD - Rotary Powered BD-4 - http://www.bob-white.com
3.8 Hours Total Time and holding
Cables for your rotary installation - http://roblinstores.com/cables/
--
Homepage: http://www.flyrotary.com/
Archive and UnSub:
http://mail.lancaironline.net:81/lists/flyrotary/List.html
|
|