X-Virus-Scanned: clean according to Sophos on Logan.com Return-Path: Received: from fmailhost02.isp.att.net ([204.127.217.102] verified) by logan.com (CommuniGate Pro SMTP 5.2.0) with ESMTP id 2717513 for flyrotary@lancaironline.net; Wed, 06 Feb 2008 09:02:22 -0500 Received-SPF: pass receiver=logan.com; client-ip=204.127.217.102; envelope-from=bbradburry@bellsouth.net Received: from arptk8ng400 (adsl-152-230-52.mco.bellsouth.net[70.152.230.52]) by isp.att.net (frfwmhc02) with SMTP id <20080206140142H0200alp69e>; Wed, 6 Feb 2008 14:01:42 +0000 X-Originating-IP: [70.152.230.52] From: "Bill Bradburry" To: "'Rotary motors in aircraft'" References: In-Reply-To: Subject: RE: [FlyRotary] Re: Flex plate Date: Wed, 6 Feb 2008 09:01:45 -0500 Message-ID: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit X-Mailer: Microsoft Office Outlook 11 Thread-Index: AchoYe0oyARQdNdrTF2pTH5PnzWD/QAZnuwQ X-MimeOLE: Produced By Microsoft MimeOLE V6.0.6000.16545 I found a wrecking yard here in Florida that claims to have 150 RX-7s in it. I haven't counted, but I suspect that may be a little on the high side. But there are a lot of them. If anyone is interested, I will get the contact info for the yard. They are located in Sanford, Florida. Bill B -----Original Message----- From: Rotary motors in aircraft [mailto:flyrotary@lancaironline.net] On Behalf Of Bob White Sent: Tuesday, February 05, 2008 8:43 PM To: Rotary motors in aircraft Subject: [FlyRotary] Re: Flex plate I'm going to need a flywheel from an 89 or up NA to match my 9.7:1 rotors. Anyone have one available? Thanks, Bob W. On Wed, 06 Feb 2008 01:01:46 +0000 "Kelly Troyer" wrote: > Joe, > A 3rd gen counterweight and flex plate will fit 2nd gen 13B but the > counterweight will put the 2nd gen out of balance unless rotors and > both counterweights from the 3rd gen are installed also...........On > another note if this engine is for an A/C using Tracy's redrive you > must use a 2nd gen flexplate........FWIW > -- > Kelly Troyer > "Dyke Delta"_13B ROTARY Engine > "RWS"_RD1C/EC2/EM2 > "Mistral"_Backplate/Oil Manifold > > > > > > > -------------- Original message from "Joe Berki" > : -------------- > > > Will a flex plate and counterweight from a 3rd gen 13b fit a 2nd gen 13b? How much for a flex plate and counterweight? Thanks for any help. > > Joe berki > Limo EZ -- N93BD - Rotary Powered BD-4 - http://www.bob-white.com 3.8 Hours Total Time and holding Cables for your rotary installation - http://roblinstores.com/cables/ -- Homepage: http://www.flyrotary.com/ Archive and UnSub: http://mail.lancaironline.net:81/lists/flyrotary/List.html