|
|
I'm going to need a flywheel from an 89 or up NA to match my 9.7:1
rotors. Anyone have one available?
Thanks,
Bob W.
On Wed, 06 Feb 2008 01:01:46 +0000
"Kelly Troyer" <keltro@att.net> wrote:
Joe,
A 3rd gen counterweight and flex plate will fit 2nd gen 13B but the counterweight
will put the 2nd gen out of balance unless rotors and both counterweights from the
3rd gen are installed also...........On another note if this engine is for an A/C using
Tracy's redrive you must use a 2nd gen flexplate........FWIW
--
Kelly Troyer "Dyke Delta"_13B ROTARY Engine "RWS"_RD1C/EC2/EM2 "Mistral"_Backplate/Oil Manifold -------------- Original message from "Joe Berki" <jskmberki@alltel.net>: -------------- Will a flex plate and counterweight from a 3rd gen 13b fit a 2nd gen 13b? How much for a flex plate and counterweight? Thanks for any help.
Joe berki
Limo EZ
--
N93BD - Rotary Powered BD-4 - http://www.bob-white.com
3.8 Hours Total Time and holding
Cables for your rotary installation - http://roblinstores.com/cables/
|
|