|
Tracy
A bit slow to respond, but I had to check an RX8 engine
and sure enough the Throttle-body was 3" not 2.75", and a lovely light throttle
body it is too.
George (down under)
Nice manifold!
I'm going to use the RX8 throttle body on mine. I consider it about
the smallest diameter usable on the 20B (about 2.75"). Virtually
anything between this and 3.25" is fine. Unless you are turbocharging,
anything larger is overkill at the RPMs we are running.
As always, YMMV.
Tracy
----- Original Message -----
Sent: Monday, May 29, 2006 11:28
AM
Subject: [FlyRotary]
Is there any particular throttle body that works best for a 20B and the
Tracy's ECM? I've attached pics of
the intake manifold I will copy.
Bob Mears
--
Homepage: http://www.flyrotary.com/
Archive
and UnSub: http://mail.lancaironline.net/lists/flyrotary/
|