|
|
Paul wrote:
Hi, Ernest.....The bolts are Allen-head, and I believe they are 10mm bolts.(don't know the thread pitch). See attached picture. Paul Conner
Thanks, Paul. I have the flex and damper plates, and plan to duplicate this setup. In my case, I will leave the backside of the clutch material in place as a spacer so that the springs have some playroom. If I remove the rivets that hold the front section of clutch material on, then I have ready made holes for 6 bolts. Unfortunately, they aren't as far out on the plate that Ross' appear to be. I'll use the largest bolts that will fit, and may enlarge the rivet hole slightly to move up to the next size.
What do the bolts screw into? Rivnuts? A backing plate?
|
|