John,
I
don’t think the there is a difference between generations as far as those
fittings are concerned. Where you
have the oil temp sensor is a water gallery. I pick up oil temp where you have your oil
pressure sender and I get oil pressure from the filter bypass block.
Hope that helps
Neil
-----Original Message-----
From: Rotary motors in aircraft
[mailto:flyrotary@lancaironline.net] On
Behalf Of John Slade
Sent: July 28, 2004 9:39 PM
To: Rotary motors in aircraft
Subject: [FlyRotary] Oil
temperature sender location
In preparation for wiring my EM2
(thanks Tracy) I'm checking that I have my sensors setup correctly.
I remember someone (I think it was
Steve) discovered that they were measuring water temp when they thought they
were measuring oil temp. I'm wondering if I'm doing the same. Attached is a
picture of the oil temp sender. Remember this is a 3rd gen engine. Do I have it
wrong?
John Slade (turbo on its way -
somewhere over the pacific)