To add to the other questions that came up, what about corners that have to
be built up?  Notably around the door, there are areas on my ES that have to
be built up to form an outside corner.  To do this the micro is pretty
thick, maybe 1/4 inch, and with it being around the door opening I'm worried
about it being bumped and breaking.  I assume this is a good place to lay a
1-BID over the top?  Very difficult to get BID to form around a sharp
outside corner, though.  I'm tempted to lay a 1-BID over just one side,
hanging over the edge and then sanding it back afterward.  That would be a
LOT less effort and I'm think it will give good protection to the corner.
Comments?

Gary Casey