|
I'm building an early 320 Fastbuild - small
tail.
Questions about the Elevator and Horizontal
Stab.
1 - Plan to use an elevator trim tab and
small RAC servo. What dimensions should I make the trim tab? I know
there are easier ways, but I am intrigued by the TruTrack auto pitch
trim.
2 - Should the elevator trailing edge have a
flat surface - similar to the ailerons? 1/4 inch like the
ailerons?
3 - Plans call for the counter balance ends to be 2
inches wide. Is this correct and adequate? Seems that they could be
made 1/4 to 1/2 inch wider.
4 - My construction manual states the correct
horizontal stabilizer incidence is -1/2 to -1.0 degree. Is this
still the proper range? If I could build with 100% accuracy, which would
be best -1/2 or -1.0?
I did search the archives but did not come to any
conclusions - thus the questions.
Looking forward to feedback and
suggestions.
Ron Kraus
LNC2 - N896BR (Reserved)
|