|
|
My EM3 has a 3 wire temperature sensor, power, ground and signal.
From what I see the EC2 only has a 2 wire sender, and a note that you can connect either wire to the EC2 so that means its a resistive sensor. The curve is not linear with a resistive senders from different manufacturers so if I dont use the same one Tracy used, for the temperature curve he programmed into the EC2 for it, the temperature values will be off and subsequently the engine tuning also off, so I dunno but I dont think I can substitute the EM3 temperature sensor either
Alex
ooops, I just noticed you're looking for the EC2 probe, That number is for the EM2. I just looked through all the info I have on the EC2 and there is no part # for the EC2 temp sensor, but I do recall that it was a different form factor than the LM34. I'd be interested to know, as that is something that would be good to have a spare.
Anyone know what the part number is for the temperature sensor for the EC2? I damaged mine modifying my intake manifold and I emailed Tracy but he appears to be out of contact at the moment, thanks in advance, Alex
|
|