On Jun 14, 2016, at 11:38 AM, William Jepson <flyrotary@lancaironline.net> wrote:

Something to remember an airbox like that must be on the "cold side" of the engine. Don't put it over the exhaust. 

Bill

On Tue, Jun 14, 2016 at 10:13 AM, Luciano, Luis I CIV PEOSUB, PMS404P <flyrotary@lancaironline.net> wrote:

Hahaha... I always heard of Tracy's simple intake manifold but never had seen the actual setup (except for zoomed out shots in Contact mag).  Now I feel better as I move forward with my build :)  Thanks for sharing Charlie!!!

Luis

-----Original Message-----
From: Rotary motors in aircraft [mailto:flyrotary@lancaironline.net]
Sent: Tuesday, June 14, 2016 12:27 PM
To: Rotary motors in aircraft
Subject: [Non-DoD Source] [FlyRotary] Re: Mistral

On 6/14/2016 9:52 AM, Tom Mann wrote:
> Any Idea as to where one might find this information?
>
> -----Original Message----- From: Charlie England
> Sent: Tuesday, June 14, 2016 9:43 AM
> To: Rotary motors in aircraft
> Subject: [FlyRotary] Re: Mistral
>
> It's not that hard to make an intake that will make great power. Look
> at Tracy's setup. Might not be aesthetically beautiful to some eyes,
> but to me, function is beauty. I don't know of any N/A 2 rotor that's
> as fast as his -4, or as efficient at lower speeds. And really simple to make.
>
> Charlie

Hope Tracy doesn't mind; here's a shot of the Renesis manifold. I believe that the tubes inside the 'box' were later extended to be near the opposite wall. IIRC, Tracy said that the tubes are ~11" from the face of the block to the end of the bellmouth.

You can see old versions of the RWS website by using the Wayback Machine & picking a date.

Charlie