|
Thomas, my machinist friend cut a grove in the case
under the prop shaft bearings so the oil would have a route to return to the
main section, also he made a retainer to secure the seal in the case. I
have to install an oil cooler for the redrive, also a temperature gauge.
I'm glassing in the inlet for the engine oil cooler now, but family matters are
slowing progress, I tell everyone it will be done in May, just not sure what
year.
I'm not sure at this
point if I should install a NACA duct or do a take off from the right side
radiator inlet duct for the transmission cooler, Ed what is your opinion on
this. JohnD
|