|
|
Ed & Group,
I brought up the question of possible use of Solid State Relays (SSR) to replace the
electro-mechanical contactors most of us use in our flying electrical systems but I need
to depend on the smarter "EE" (Electronic Engineer) types of our group to tell me if this
would be a good idea...........To the electrically challenged (Me) they look good.......Light
weight, small, low operating voltage (down to 3 volts), low current draw, low voltage drop,
high surge amp survival, etc..............They do require a heat sink to utilize their maximum
amp capibility............They do cost considerably more than the contactors but do not wear
or degrade and if used within their limits will probably last longer than me...........
I have included a link to the company that made the SSR that I have purchased on
blind faith that it would serve as my master relay........It is a "Power-IO" model HDD-06V75
which has been upgraded since my purchase by the HDD-06V75E which will operate at
a lower voltage,lower drop and lower current draw............Both versions will stay operated
at down to 1 volt..........Looking forward for a critique of this idea pro or con...............<:)
Kelly Troyer
"DYKE DELTA JD2" (Eventually)
"13B ROTARY"_ Engine
"RWS"_RD1C/EC2/EM2
"MISTRAL"_Backplate/Oil Manifold
"TURBONETICS"_TO4E50 Turbo
From: Ed Anderson <eanderson@carolina.rr.com>
To: Rotary motors in aircraft <flyrotary@lancaironline.net>
Sent: Monday, August 22, 2011 8:37 PM
Subject: [FlyRotary] Re: One Battery - Two Battery was [FlyRotary] Re: Batteries
Yes, Kelly, back a few years ago, I did look into them. The models I looked at had some strange characteristics that I didn't fully understand (and didn't take the time to), so I passed. Besides in my case 3 volts would taken me a bit closer to the airport before the relay let loose, but would have done nothing to provide a solution for my problem - head up and locked {:>).
I'm still waiting for the 16X before I start anything major new on my aircraft - hope won't have to wait too much longer.
Ed
Sent: Monday, August 22, 2011 8:48 PM
Subject: [FlyRotary] One Battery - Two Battery was [FlyRotary] Re: Batteries
Ed,
Have you ever considered "Solid State Relays" for contactors..........The DC versions will operate
at down to 3 volts and draw a lot less amperage than the electro mechanical versions...........
Kelly Troyer
"DYKE DELTA JD2" (Eventually)
"13B ROTARY"_ Engine
"RWS"_RD1C/EC2/EM2
"MISTRAL"_Backplate/Oil Manifold
"TURBONETICS"_TO4E50 Turbo
From: Ed Anderson <eanderson@carolina.rr.com>
To: Rotary motors in aircraft <flyrotary@lancaironline.net>
Sent: Monday, August 22, 2011 4:12 PM
Subject: [FlyRotary] Re: One Battery - Two Battery was [FlyRotary] Re: Batteries
Yes, I have also found my GPS can get confused - especially in the inner city (where you need it the most). So can my brain when tired and/or under pressure - the old brain can do some not so funny things.
I left out one important fact about why the switch in the wrong position caused the engine out landing.
When I had designed that switch in to disengage the battery from the alternator (in case of an over voltage condition), the switch not only removed the battery from the alternator line - but also all my critical systems (fuel, ignition) which were "smartly" tied to my battery bus. So even though the alternator was putting out plenty of power - even if the battery had been stone, cold dead, it could have powered all of those power hungry devices. But having all of that on the battery bus and the battery bus disconnected from alternator - that pulled that battery down even quicker.
So the fact that it last 45 minutes including cranking drain for engine start says a lot about the Odyssey PC 680.
Sent: Monday, August 22, 2011 2:44 PM
Subject: [FlyRotary] Re: One Battery - Two Battery was [FlyRotary] Re: Batteries
Ed,
Thanks. I remembered you discussing it, but now it makes sense why you didn't see the low voltage warning from the battery.
I know that 'fixation' issue, all to well. On business I'm always running between meetings in new cities, and got to the point where I really loved (& blindly trusted) my Garmin GPS. Well in Phoenix there was an "W.Shangri-La Rd" vs "E. Shangri-La Rd". Van full of hungry people wanting dinner, and I kept following the GPS... despite a passenger in the back telling me I was taking the wrong route. I just figured the GPS was smarter as it rcd traffic information, and would get us there faster! Had I thought to look at a map, or listened the my passenger, but with a load of
people, 5pm traffic, and overload after a day in the sun.... my brain wasn't working. Live and learn!
Tom
From: Ed Anderson <eanderson@carolina.rr.com>
To: Rotary motors in aircraft <flyrotary@lancaironline.net>
Sent: Monday, August 22, 2011 12:27 PM
Subject: [FlyRotary] One Battery - Two Battery was [FlyRotary] Re: Batteries
Actually, Tom, in that particular incident - a second battery would have only enabled me to fly too far away from the only safe airport to make a return and dead stick into. IF I had realized the root cause (a switch accidently put in the wrong position) then one battery would have worked just as well as two {:>).
Having said that, I certainly would not try to get anyone to change their mind about using two batteries. . Some folks would not feel comfortable even with two batteries - but, would add a second alternator, etc. So, you have to think through your scenarios, the risk involved and your personal risk tolerance. Yes, Bob now has several good electrical designs - for just about any kind of power system you could come up with. Back in 1992, I had never heard of Aeroelectric or Bob.
But, since my previous engine out almost 5 years previous had been fuel related and the engine was sputtering in a similar manner - my diagnostic side of the brain got locked in to searching for a fuel problem (again) - but even switching tanks did no good - because, this time the "fuel problem" was a decreasing electrical power. This incident clearly pointed out the need for an emergency check list that involved checking both fuel AND electrical systems. Coming up with one in your head with the engine sputtering is not recommended {:>)
Contributing factors were two early design decisions that on hindsight revealed shortcomings.
One was an electrical system design that permitted my voltmeter to keep showing me the 13.8 volts being generated by the alternator while the battery voltage was steadly decreasing. Yes, I had a low-voltage light right in front of my eyes - but, it was wired into the alternator powered circuit - so never showed low voltage because the alternator voltage was fine - up to the point the relay released.
Now, had it occurred to me I might have an electrical problem - and switched the volt meter to the battery (instead of alternator) AND had thought to observe it, I would have seen the battery voltage decreasing and that MIGHT have got me looking for an electrical problem rather than a fuel problem. But, when you get your head locked into one focus - and you truly have mental blinders on, NOT GOOD!
The second design deficiency was that the relay holding the alternator On-Line was provided current solely by the battery - so guess what happened when the battery juice got too low to hold the alternator on-line? Right "CLACK!!!!!" followed immediately by all lights, radios, LEDS, panel going dark. It gets even lonelier when the lights go out. Had I two batteries - all of this would have happened further from my emergency airport in Salem, Al.
No, I have not added the second battery back in after the incident - because in my particular case, the incident had nothing to do with one battery vs two battery - it was a case of a mis-positioned switch which the pilot never recognized was the cause - until later on the ground, cleaning off the seat cushion. The corrective action was to put a switch guard over that particular switch so it could NOT be accidently toggled incorrectly AND rewire my relay so that a dead battery would no longer prevent my system from using the power of a perfectly good alternator.
But, this is just my perspective - provided for anyone to glean what they wish from it - if that is two batteries, two alternators or what have you, then as always in this hobby, that is up to individual choice.
Just don't make the same dumb mistakes I made, we know how those turned out - advance the state of the art and make NEW mistakes {:>)
Oh, yes, the switch I accidently activated (I think I probably hit it with my foot getting out of the aircraft at the previous refueling stop) was one that enabled me to detach my battery from the alternator. The thought at design time was that if my alternator ran-away with high voltage, I could isolate the battery from the alternator thereby preventing the battery from overheating/boiling and get to an emergency landing on battery power alone. Seemed like a good idea at the time.
Ed
Sent: Monday, August 22, 2011 12:35 PM
Subject: [FlyRotary] Re: Batteries
Joe,
Which Bob Knuckles system? Z19?
I realize Ed is happy with one battery, but I like two batteries. The THUNK of relays all popping open and the realization of "I turned off the alternator, and voltage dropped way too low.... followed with LAND NOW!" would have convinced Ed to have put the second battery back in! It sure got my attention on why two batteries is a good thing!(Great Story, but I'll let Ed tell it!)
So two batteries, and a BIG RED LIGHT with "low voltage" will go on my panel.
I did the spread sheet with 17AH batteries and flying time. Add in Night, and no place to easily land.... two batties seem like a good trade off. My biggest shock was the FORD style contactor needed 1Amp draw to remain closed. Shutting down non essential, but leaving contactors, PDF, ECU and coils.... System draw is around 15 Amps. 17AH implies you'd have an hour, but at 15Amp draw... more like 30-40 minutes, hence two batteries as 1 hour flying time makes finding a landing strip a little easier.
Tom
From: Ed Anderson <eanderson@carolina.rr.com>
To: Rotary motors in aircraft <flyrotary@lancaironline.net>
Sent: Monday, August 22, 2011 11:20 AM
Subject: [FlyRotary] Re: Batteries
Joe, I started out using two Concord 25AH RGB each weighing 22 lbs for a total of over 44 lbs of battery (some joked I could get home by using the start to crank the prop {:>)) ! I then transition to two Odyssey PC-680 17AH batteries
each weighing 14 lbs for a total of 28 lbs. Then after 6 years of flying with two batteries and never using the second one - except to help crank on a cold morning, I removed one of them. Have now been flying for over 4-5 years with one Odyssey 14lbs. I swap it out every two years. Ed -------------------------------------------------- From: < jskmberki@windstream.net> Sent: Monday, August 22, 2011 11:59 AM To: "Rotary motors in aircraft" < flyrotary@lancaironline.net> Subject: [FlyRotary] Batteries > What size an type of batteries are required for the rotary? I am leaning toward using 2 batteries and use Bob Nuckols
system. Thanks for any help. > > Joe Berki> Limo EZ> > -- > Homepage: http://www.flyrotary.com/> Archive and UnSub: http://mail.lancaironline.net:81/lists/flyrotary/List.html -- Homepage: http://www.flyrotary.com/Archive and UnSub: http://mail.lancaironline.net:81/lists/flyrotary/List.html |
|