|
Bob, Joe and Richard,
Thanks Guys everyone's correct, my Son got the same
answer.
So Richard, if I tell my grinder to grind a 10:1
taper over 30mm, he should know what I mean. I'm glad it's a common taper, now
that I know it's used in all these things I may use it again for other
things.
George (down under)
You are right Joe, but the taper denominator is,
metric taper 10:1 . It is used in lots of power transfer taper joints. All
Rotaxes, Kawasakies and lots of other small engines, aircraft and others, are
using it. I am using it on the single rotor too.
Richard Sohn
N2071U
----- Original Message -----
Sent: Friday, January 11, 2008 9:20
PM
Subject: [FlyRotary] Re: Angles
Hi George,
Not Ed, but if my trig is not too rusty the
angle should be 5.710593 degree.
Joe
----- Original Message -----
Sent: Friday, January 11, 2008 7:42
PM
Subject: [FlyRotary] Angles
Ed,
I measured the taper of the flywheel taper
with a ruler, the draft is 3mm in 30mm. I checked that with a dial
indicator and it was correct - how does one derive the angle of
that?
Is it 6 degrees?
George (down under)
No virus found in this incoming message.
Checked by AVG Free
Edition.
Version: 7.5.516 / Virus Database: 269.19.0/1218 - Release
Date: 1/10/2008 1:32 PM
No virus found in this incoming message.
Checked by AVG Free
Edition.
Version: 7.5.516 / Virus Database: 269.19.0/1218 - Release Date:
10/01/2008 1:32 PM
|