I can't remember the thread size, but it was readily available as a metric bolt. I cut off a bolt, used a dremel tool with abrasive wheel to cut a screwdriver slot in one end, and plugged them that way (makes it flush).
Bill Schertz
KIS Cruiser #4045
----- Original Message ----- From: "David Staten" <Dastaten@earthlink.net>
To: "Rotary motors in aircraft" <flyrotary@lancaironline.net>
Sent: Tuesday, August 14, 2007 10:26 PM
Subject: [FlyRotary] Re: Plugging Oil Injector Ports

jewen@comporium.net wrote:

What is the thread size for plugging the oil injector ports? Does anyone have a source?

Thanks,
Joe

ugh... had i known i'd have measured. I was at the hangar tonight. If you have an oil injector laying around, take that with you to a bolt shop. They can measure and get it for ya. Length wise, dont need too long. 10 mm is fine lengthwise.

Dave

--
Homepage:  http://www.flyrotary.com/
Archive and UnSub: http://mail.lancaironline.net:81/lists/flyrotary/List.html

--
Homepage:  http://www.flyrotary.com/
Archive and UnSub: http://mail.lancaironline.net:81/lists/flyrotary/List.html