|
|
I wonder if Tracy's reduction uses any components that rely on a heated
press fit for retention. Lynn;
Rear seal is retained with a bolted flange. I don't think there is
anything
relying on heated press fit.
Al
The rear seal in my plate is a press fit (RD1C). It's tight, so I don't
think there is any need for heat to keep it in.
Bob W.
Oops; rear seal in a pusher is the one nearest the prop hub. Yes, on the
other end is a stiff elastomer seal pressed into a recess in the mounting
plate. I don't think that one is going anywhere.
Al
|
|