|
Message
Soldered the wires directly
to the injector leads and
potted them in epoxy. Replaced the wires
between the EC2 and both sets
of injectors with shielded wire, with
the shield grounded at the EC2
end only. That's about it.
Hi
Buly,
OK, gotcha. Not
too many changes. I know it's been mentioned to try the old wires, and I
also know what a pain that would be to do. Have you actually tried
that? If not, do you have a spare injector that you could wire up
temporarily?
Basically, I'm
suggesting that you disconnect one injector, then temporarily connect a
spare injector in it's place. You'd run 12V to one side, then connect a
jumper wire from the other side, to the EC-2 connector that goes to the injector
you unplugged. Put the EC-2 in simulate for the injectors, and see if the
jumpered injector works while the others don't.
I admit that I've been
skimming through all the posts, so if you've already done this, just disregard
this message :-)
Being a retired guy with
nothing better to do, I'd think Ed would run down there to give you a
hand. Nah, I'm sure he couldn't fix it (snicker, snicker)
:-)
Rusty (trouble is my
middle name)
|