|
|
Pins 33 and 34 are correct, and power to either one should power both
processors (unless Tracy did one of his stealth improvements).
Bob W.
On Sat, 19 May 2007 16:38:28 -0800
"Al Gietzen" <ALVentures@cox.net> wrote:
NOTE: In the prior message below I mention the power input pins as 33 and 34
- that's what it is on my 20B version. It could be different on the 2-rotor
version (although unlikely).
Al
Buly;
Two things: Have you checked that the processor chip(s) are fully seated in
plug (base); and - is the behavior the same for both controllers?
If you have +12 power to pins 33 or 34, and you have the serial lead
connected to the EM2, and the processor in functioning, you should not see
NOP. Possibly something has happened in shipping or handling. If the
processor is not functioning of course you can not trigger the injectors. Good luck,
Al
--
Homepage: http://www.flyrotary.com/
Archive and UnSub: http://mail.lancaironline.net:81/lists/flyrotary/List.html
--
N93BD - Rotary Powered BD-4 - http://www.bob-white.com
3.8 Hours Total Time and holding
Cables for your rotary installation - http://www.roblinphoto.com/shop/
|
|