|
Should not be a problem, Greg. However, I would
suggest removing them in the same order as shown for disassembly (cross hatch
pattern), putting on the silicon and then tightening that bolt down before
removing the next one. If you have torqued them down previously, then I
would also consider replacing the tension bolt washer (or "O" ring if using
Tracy Crook's Tension bolt washers). Its a pain to have to re-take the
engine off or the gear box off just to replace a leaking tension bolts
washer{:>).
Ed
----- Original Message -----
Sent: Sunday, June 25, 2006 4:05 AM
Subject: [FlyRotary] renesis mods
I'm about to mod the eccentric shaft oil bypass
valve and put the spiral of silicon around the tension bolts.
Question is it ok to remove one tension bolt at a
time without affecting the internal oil and water seals?
Thanks
Greg RV8
|