|
Message
Have you worked -out all your requirements for the
single rotor. It not as simple as it first appears, but not so complicated when
it's all said and done.
I guess your turning down a RX7 e-shaft and
filling the extra holes.
Hi George,
I haven't pushed the single rotor project much, because
I've been too busy with the RV-3. I did just buy a complete single rotor
engine off Ebay, and will peek inside soon. I know I have to fill in at
least one hole on the shaft, but otherwise it all seems usable. Seems to
be older housings, but I won't know how old until I get inside. I'm not
sure if I'll use this engine in it's entirety, or use the REW housings I already
purchased. It will probably depend on what I find inside.
Cheers,
Rusty (gotta make a new intake for the RV-3
first)
|