|
|
Right on. It says re-scheduled. Too bad it didn't get here today. I don't
remember when it was originally scheduled, so is it early or late? I should
get it tested next week though. (Rusty sent me his Craig-Davies pump to
measure on the same setup I used with the WP136's) The hardware store had 1 1/4 fittings and 1 1/2 fittings so I got the 1 1/4.
Maybe I can wrap enough tape around it to get a seal since the pressure isn't
much.
I bought some Earl's Pro-Lite 350 hose from Summit. It is a nylon braid and
fits the Earl's reusable swivel ends. It's good to 300 psi and 350 F. It's
also a lot more flexible than the hoses I had made. Am I going to lose much
reliability by using this instead of the stainless steel braided hose? The SS
hose has a better pressure rating, but both are way over rated for what I need.
Bob W.
On Thu, 24 Mar 2005 20:35:33 -0600
"Russell Duffy" <13brv3@bellsouth.net> wrote:
I received the new WP337 water pump today. The WP136's are at the airport,
but just looking at it, the motor is bigger in diameter and shorter. If not
too much goes wrong, I will make some flow measurements tomorrow. I will at
least get a comparison photo of the two pumps.
According to UPS, you'll have another pump to test tomorrow :-) Cheers,
Rusty (looking forward to the results)
--
http://www.bob-white.com
N93BD - Rotary Powered BD-4 (real soon)
|
|