----- Original Message -----
Sent: Friday, February 18, 2005 7:35
PM
Subject: [FlyRotary] double sheave alt
pulley?
Greetings,
I'm using the fairly
standard little ND 55A alternator, which has a 15mm shaft. It comes with
a single sheave pulley, and I've always planned to change that to a dual
pulley. At one point, I found that the stock Mazda alt had a 15mm shaft,
so I ordered one of the dual pulleys from Racing Beat. Since I had the
alt off, I decided to install the new pulley, but after much effort to get the
old one off, I found the new one won't work, so I'm back to my single belt
pulley again. The hole was the right size, but the rear side of the
pulley needs to be flat, and the Racing Beat pulley is dished on the rear
side.
Is anyone running a dual
pulley on one of these? If so, where did you get
it?
The engine is installed
again, as well as the redrive, radiators, intake, and exhaust. I also
stepped down to the 38 lb/hr injectors, rather than the 50 lb/hr injectors I
was using. If these turn out to be too small, someone will pay :-)
Still got a long way to go.
Rusty
No virus found in this incoming message.
Checked by AVG
Anti-Virus.
Version: 7.0.300 / Virus Database: 265.8.8 - Release Date:
2/14/2005