...Another idea is drill holes through the plexiglass in the
bonding
area to allow hysol squeeze through...
back side...
Good way to crack the plexiglass unless a special drill is used. I've
seen it happen (no not me).
Gary Edwards
LNC2
----- Original Message -----
Sent: Sunday, November 20, 2011 3:57
PM
Subject: [LML] Re: Window Bonding
Suggestion;
I assume you sanded the plexiglass to
provide some tooth for hysol bonding.
100 or lower grit. Another idea is
drill holes through the plexiglass in the
bonding area to allow hysol
squeeze through and mechanical bonding on the
back side. I also
incidently applied a two bid fiberglass over the
plexiglass bonding area
and about 1/12 inches on the fuselage sidethus
capturing the
glass.
Hope this helps out.
Bob Smiley
360
94RJ