Nick….here is the point in my builder's log where I did the seat belts.  The first few pics are when the fuse top was still off and upside down.  Did the same as Bob…figured left side as how it should be as oriented to door, then made it the same on the right side.  I made note of the measurements in the log entry.  There are some add'l pics later on.

AMSAFE also….I did get them through Lancair.

http://www.mykitlog.com/users/display_log.php?user=n144gp&project=471&category=3278&log=101017&row=265

Gordon N144GP

sloshing and hanging wings (for the last time I hope!) this weekend…..

Nick:

I have the rear seat upholstry out of my IV-P and would be happy to send you a photo of the inertia reel installation.  BTW, I found it beneficial to take a belt and suspender
approach using  both seat belts and inertia reel.

Let me know.  Bill Hogarty



On 8/29/2011 11:07 AM, Nicholas Paczkowski wrote:

I am planning to install inertial reel shoulder harnesses harness for the front seats of my LIV (under construction). I have seen the archived posts on the topic but am still not clear as to how (and where) to create acceptable anchor points for the upper (shoulder) harness in a non-pressurized IV. If anyone could point me in the right direction it would be greatly appreciated. Also I am also looking for recommendations  for a manufacturer. Thanks.