Mailing List lml@lancaironline.net Message #56651
From: Bryan Wullner <vonjet@gmail.com>
Sender: <marv@lancaironline.net>
Subject: Re: [LML] 360 flap failure
Date: Wed, 10 Nov 2010 07:49:47 -0500
To: <lml@lancaironline.net>
 Message Header

Undecoded Message
This happened to mine. It extended to far out as I didn't have the stop limits in place. Once it extended it and stopped working.  If I remember right had to reverse it by hooking the leads directly to a battery and retracting it slightly.

On Tue, Nov 9, 2010 at 9:32 AM, jon hadlich <hackmo15@gmail.com> wrote:
By pass all the limit switches and relays going directly to the flap motor leads with a external battery (drill motor) to get the flaps back into the usable range.Then verify the wiring of the limit switch and the relays along with the flap switch itself. Also verify that  the limit switch is operational. The only way the flap motor will go beyond the limit switch is if it's failed or miswired.

--
Jon Hadlich
AI Systems
(541) 815-7381

Subscribe (FEED) Subscribe (DIGEST) Subscribe (INDEX) Unsubscribe Mail to Listmaster