Hi Bob,
It would be interesting to note whether your AC is the early version/or
late. The difference is the dimension that the scoop extends down from the
fuselage. I don't recall the exact figures but the next time you're at the
airplane with a rule--- get the measurement from the center of the
fuselage down to the top of the scoop. This will tell me whether or not
you will gain anything from the conversion. The later models with the
scoop tucked up close to the fuselage had very little drag.
At any rate-- if you do intend to make this change-- do a test flight
before you start and get some indicated airspeed runs at various
altitudes. Make sure the engine power figures are recorded also.
Then we can have definitive data to support this
long-standing debate.
After I installed mine, I compared that data from a prop test I had
done a year earlier for MT propeller--testing the three Blade versus the
four blade. And compared that data with the AC data at the same altitudes
in power settings. There is always some scatter but I found that 3 kn was
the average penalty.
And--what you will be able to establish that I was not-- how much does
the condenser cooling exhaust causes drag. As you can imagine if this
exhaust air is strong enough you will have to trim the airplane nose up
(causing drag). Also, very exhausting at 90° to the flow of air over the
skin, will cause drag. How much we don't know.
At any rate it will be a very interesting test.
Thanks