Would shimming the support plate with washers help?


-----Original Message-----
From: Lancair Mailing List [mailto:lml@lancaironline.net] On Behalf Of
Dan Ballin
Sent: March 21, 2010 19:41
To: lml@lancaironline.net
Subject: [LML] Baffling install on a Legacy with EI

For all of you Legacy buildings, IO-550 and a Light Speed EI, I have a
question about where to mount the front baffling.  It makes sense that
it should be in front of the metal mounting plate for the sensor ring,
but when I did this, the metal plate distorted.  The front plates
overlap and you then loose the flat surface for the mounting plate.  I
am going to try putting the mounting plate aft of the baffling, but it
is going to require a little work to get the fit right.

How did you do it and any suggestions?
Pic is attached (hopefully small enough Marv)

Dan Ballin
LEG2 #286