Mailing List lml@lancaironline.net Message #47449
From: <PJHWFD@aol.com>
Sender: <marv@lancaironline.net>
Subject: Fwd: [LML] Re: Oil leak
Date: Wed, 28 May 2008 20:55:32 -0400
To: <lml@lancaironline.net>
 
 

From: PJHWFD
To: lml@lancaironline.net
Sent: 5/28/2008 6:41:08 A.M. Eastern Daylight Time
Subj: Re: [LML] Re: Oil leak
 
Steve
I to had oil blowby problems and ended up installing an Andair oil separator. I installed a backet on the left accessory case and drained back intoa hex bolt below the separator. This did not work and I had results similar to you. My feeling is that I was getting back flow off high pressure oil from the drain. Lancair recomended this Location. I switched the drain to the valve cover which is where Beechcraft and Cirrus loccation theirs. End off problem for me.  Now using less than qt/5hrs and a clean belly.  What is your separator setup?
Peter Hebert

-----Original Message-----
From: Steve Colwell <mcmess1919@yahoo.com>
To: lml@lancaironline.net
Sent: Tue, 27 May 2008 6:54 pm
Subject: [LML] Re: Oil leak

Michael,

Tests for cowl air pressure penetrating the case have been inconclusive so
far. The latest attempt to find a crankcase air leak was a very sensitive
test instrument pulling vacuum on the crankcase while I hosed down every
penetration point on the engine top and bottom with a high volume air
compressor.

The balloon and soap suds test found a very small leak where the steel tube
for the rubber vent line enters the dip stick housing.  JB Weld fixed that.
When aluminum tape was applied to the Dipstick to Dipstick Housing, tie
wraps were also used for double security during the flight test. 

Steve Colwell  Legacy  916 505-6099



You Said:

During runup and takeoff roll the manometer (tapped into the crankcase vent
about the mid-point of its length) will read zero until plane has about 120
knots indicated airspeed.  At 120 to 200 knots the manometer reads 4" to 5"
with a MOMENTARY spike up to 14" to 20" when power is reduced in the
pattern.

This symptom suggests that airspeed is pressurizing the case and pushing oil
out. Check the Oil filler cap for a proper gasket and for proper sealing of
the gasket.







--
For archives and unsub http://mail.lancaironline.net:81/lists/lml/List.html




Get trade secrets for amazing burgers. Watch "Cooking with Tyler Florence" on AOL Food.
Subscribe (FEED) Subscribe (DIGEST) Subscribe (INDEX) Unsubscribe Mail to Listmaster