<<<<<<<<<<<<<<<<--->>>>>>>>>>>>>>>>
          <<  Lancair Builders' Mail List  >>
          <<<<<<<<<<<<<<<<--->>>>>>>>>>>>>>>>
>>

> You simply capture the shank of a male rod end bearing between
> the cable adjusters and drill 3/16" holes through the shank of the rod end
> bearing (holes are already pre-drilled in the cable adjusters).
>
Oops!! I should have written FEMALE rod end bearing. I'm writing all this
from recollection and don't have references handy, but I believe the rod end
bearing to use is an HFE-3.
Bill Rumburg
N403WR  (Sonic bOOm)
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
LML website:   http://www.olsusa.com/Users/Mkaye/maillist.html
Builders' Bookstore:   http://www.buildersbooks.com/lancair

Please send your photos and drawings to marvkaye@olsusa.com.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>