|
|
I need to shorten its fully extended length.
Angier, by how much do you need to shorten it? If it is less than 1/2 inch, you MIGHT be able to just cut off the shaft at the thread end. As long as you have adequate thread to engage the rod end, this will work. (at least it worked in ours). Of course doing that also shortens the retracted length so you'll need to see if you can adjust spacers to keep the retracted length where you want it.
Bill Harrelson
5zq@cox.net
N5ZQ 320 1,100 hrs
N6ZQ IV 3.673%
|
|