|
|
The answer is "yes", Paul
However, you need to make certain that the sensor is a match for your
gauge else it could cause a misrepresentation of temperature. Normally, the
best bet is to try the manufacture/distributor of the temperature gauge -
frequently they have a number of different plug/screw sizes with a common
sensor element
What make temp gauge do you use for your oil??
Ed Anderson
RV-6A N494BW Rotary Powered
Matthews, NC
----- Original Message ----- From: "sqpilot@earthlink" <sqpilot@earthlink.net>
To: "Rotary motors in aircraft" <flyrotary@lancaironline.net>
Sent: Sunday, June 27, 2004 4:14 PM
Subject: [FlyRotary] Oil temp sensor
Hi, fellow rotary enthusiasts....I am trying to find out if anyone has
located, or is using, an oil temp sensor that is a male pipe plug thread,
ie....1/4 NPT or 3/8 NPT. That would be the simplest installation for me.
Any and all suggestions and/or sources would be much appreciated. I have
run my engine for approximate 10 minute intervals, and the water temp has
been fine, but don't know about oil temp yet, as I need this sensor.
Thanks
in advance for all replies. Paul Conner, 13b powered SQ2000 canard
>> Homepage: http://www.flyrotary.com/
>> Archive: http://lancaironline.net/lists/flyrotary/List.html
|
|