Finn, Not a stock manifold, made from 321
S/S. Drilled in and welded
boss for probes. One each end as it came out
from exhaust port each
end. Neil.
> Curious how you could place them 4" from
the port(s).
>
> The Renesis manifold has at least two
layers. Center ports? Outer ports?
>
> Finn
>
>> finn,
>>
>>
?????????????????????????????????????? I put 2 EGT's in
the standard
>> position of 4 inches from the port,
and really there was no
>> difference except that I kept
burning both off.?? Their usefulness,
>> and one will do, is to regulate high
temps with either revs (lower)
>> or a richer mix to lower the high
EGT. 1800 degrees F is quite warm
>> and will test the exhaust system.??
The probe just lets you know if
>> you are wasting your time or
actually achieving something.?? Once set
>> up they are just another thing to
worry about in my case, so
>> currently running without.
>>
>> Neil
>>
>>> For those of you that are using
the stock manifold, where/how did
>>> you locate the EGT probes?
>>>
>>> With an O2 sensor, I'm not sure
that a single EGT probe has much
>>> usefulness. However, one for
each rotor would give indication of
>>> mixture imbalance between the
two rotors.
>>>
>>> Finn
>>>
>>>
>>> --
>>> Archive and UnSub:
>>
>> --
>> Archive and UnSub:
>>
>
>
> --
> Archive and UnSub:
--