flyrotary@lancaironline.net Mailing List Archive

I have a CG Mount, 20B for a pusher that may well work for you. Its never been installed. Click me back if you think you can use it.May save you a lot of time and some bucks!

Thanks

Tom

From: Mark McClure <flyrotary@lancaironline.net>
To: Rotary motors in aircraft <flyrotary@lancaironline.net>
Sent: Monday, July 10, 2017 4:36 PM
Subject: [FlyRotary] Engine Mount design

Well I think I have designed my mount for the Glasair. Overall I think it will be a bit overkill but I am ok with that.

Should put the CG close to the same spot as for the Lyco. Thrust point in the same spot. Green bars were part of the Glasair mount for a Lycoming. (There was also one between the two upper points but I don’t think any of them are truly necessary with the stabilization of the plate. Yellow bar I am calling optional at this point to make it easier to work with intake/exhaust. Another idea we had was to weld on a flange for both sides of the yellow bar and have it bolt on during final install.

Thoughts?

Mark