|
|
Ernest,
FWIW I'm using 2.5" pipe after the exhaust manifold. 7500 rpm at 40" MP
is not a problem. Bobby
-----Original Message-----
From: Rotary motors in aircraft [mailto:flyrotary@lancaironline.net] On
Behalf Of Ernest Christley
Sent: Tuesday, May 29, 2012 1:12 PM
To: Rotary motors in aircraft
Subject: [FlyRotary] Re: Exhaust temp
Lehanover@aol.com wrote:
I was hoping you wouldn't see this, but now that the cat is out of the
bag............
You can see the need for some shielding between the headers and any items that you don't want at the same temperature. Radiant energy is line of sight. If the header can see it, up goes the temperature.
Pieces of .015" stainless stood off the header about 1/2" to 3/4" breaks the line of sight. Building such on the header reduces the amount of material involved. It is easier to not heat things up than it is to cool it after you have. Use 1/4" hose clamps to hold onto the
shielding.
A small blast tube to keep things moving past the headers is helpful.
I can make a picture if you like. Helps keep heat out of the intake system and thus more power. Very easy. Amazing results.
Lynn E. Hanover
My exhaust is encased in a .015 stainless box down to the end of the
collector. The down pipe and muffler are exposed, and I see where it is
blistering the belly paint already. I'll be wrapping more of the
exhaust in the thin stainless.
I will also open the stainless box up to allow some blast air through.
First I have to change that down pipe from 1.5"
dia to 3". I can't seem to get above 5100RPM, and I think exhaust
backpressure is my issue.
--
Homepage: http://www.flyrotary.com/
Archive and UnSub:
http://mail.lancaironline.net:81/lists/flyrotary/List.html
|
|