On the attached picture, the items requiring identification are likely Manifold Pressure sensors and Inlet Air Temp sensors. We bought the intake without them installed and routed plumbing from 2 ports to the EC2 MAP sensors, and put a thermocouple in the third port.

When I saw We, I am referring to Chris Barber's Mistral intake that I helped acquire and install for him. \\\

Dave

On 4/20/2011 1:01 PM, Jack Hilditch wrote:

Kelly,

 

I corresponded with Chris Barber before posting on the forum because I thought the topic might b too specific since there seem to be so few Mistral parts floating around. I wanted to see if Chris had any information or knew of a location where I could get some. Chris suggested I post my question to the group so I did and everyone was most helpful but I still don’t have the documentation I’m looking for. Would anyone happen to have an email address for Steve Thomas since he is actually running a Mistral?

 

Also, would anyone know what the four items I’ve pointed out in the attached image are used for (in a non-Mistral context)?

 

Thanks,

 

Jack Hilditch

RV-9A project

---

From: Rotary motors in aircraft [mailto:flyrotary@lancaironline.net]
Sent: Sunday, April 17, 2011 6:01 AM
To: Rotary motors in aircraft
Subject: flyrotary Digest #3136

 

No virus found in this message.
Checked by AVG - www.avg.com
Version: 10.0.1170 / Virus Database: 1500/3578 - Release Date: 04/16/11

--
Homepage:  http://www.flyrotary.com/
Archive and UnSub:   http://mail.lancaironline.net:81/lists/flyrotary/List.html