|
|
On 1/21/04 4:33 PM, "Scott" <squiggles@yahoo.com> wrote:
I have attached two photos...
On the "where does this hole go" I would like to know
where the lower left hole of the side engine mount
hole goes.
On the "how far setback" I am contemplating using
these holes as part of an engine mounting point. I
was hoping somebody had already gone this route and
had determined the offset of the front cover bolt
holes from the end housing holes.
Thanx...
-Scott
=====
Thank You.
Regards,
Scott Stout
12345 holes are where the AC compressor mount goes. You can measure the
difference with straight ruler and calipers. I did it, but forgot. Most of
people use this area for alternator mounting pad. I'm loosing my sleep over
the design myself.
The other hole, I don't know. On mine, there is a long hex-headed stud.
Bulent
|
|