Mailing List flyrotary@lancaironline.net Message #47329
From: Jeff Luckey <JLuckey@pacbell.net>
Subject: RE: [FlyRotary] Re: WTF? Just when I think everything is going perfect...
Date: Tue, 21 Jul 2009 09:01:39 -0700
To: 'Rotary motors in aircraft' <flyrotary@lancaironline.net>
I knew that... just couldn't remember (duh!), I think "my cup runneth over"
with TLA's (three letter acronyms)

Thanks for the reminder


-----Original Message-----
From: Rotary motors in aircraft [mailto:flyrotary@lancaironline.net] On
Behalf Of Bob White
Sent: Monday, July 20, 2009 20:40
To: Rotary motors in aircraft
Subject: [FlyRotary] Re: WTF? Just when I think everything is going
perfect...

On Mon, 20 Jul 2009 20:24:54 -0700
"Jeff Luckey" <JLuckey@pacbell.net> wrote:

CAS?  = Crank Angle Sensor

 

  _____  From: Rotary motors in aircraft [mailto:flyrotary@lancaironline.net] On
Behalf Of David Leonard
Sent: Monday, July 20, 2009 18:19
To: Rotary motors in aircraft
Subject: [FlyRotary] Re: WTF? Just when I think everything is going
perfect...

 

Yup, spins with no sign of firing at all!  It only spins easily by hand
when
the plugs are out..  otherwise it is a one-compression-at-a-time kind of
exercise.  Compression is normal..  I am well familiar with its feel.  I am currently leaning toward a intermittent condition with my CAS wiring
or
the bad gas/flooding issue.  At least it has made me think harder about my
CAS as a single point failure and review the wiring.

Thanks for all the suggestions.

Dave Leonard



On Mon, Jul 20, 2009 at 11:59 AM, Charlie England
<ceengland@bellsouth.net>
wrote:

David Leonard wrote:

Yesterday I went flying and tested out my new smoke system... everything
was
perfect...  somke is fun.  Today I head out to go formation flying..
nothing changed from my flight yesterday except for adding fuel.  But it
won't start...   I verify that I have fuel pressure, fuel flow, injector
function (in test mode), I have spark (in test mode).  Maybe it is
flooded... I change the plugs, re-verify spark in cranking mode (to
eliminate issues with CAS), re-drain the fuel, verify compression,
re-verify
fuel pressure and flow and injector funcion... but still it just turns
over
without starting...  Sigh

Anyone one know of a new component necessary other than fuel, spark, and
compression?



--
N93BD - Rotary Powered BD-4 - http://www.bob-white.com
3.8 Hours Total Time and holding
Cables for your rotary installation - http://roblinstores.com/

--
Homepage:  http://www.flyrotary.com/
Archive and UnSub:
http://mail.lancaironline.net:81/lists/flyrotary/List.html

Subscribe (FEED) Subscribe (DIGEST) Subscribe (INDEX) Unsubscribe Mail to Listmaster