Al,
How well does your engine cool on the ground? What is the max rpm
that your coolant temp will stabilize within your upper limit and what is the
temp at that rpm?
Do you have any fans or otherwise pulling air thru the radiators when
sitting on the ground?
Tracy
tells me that I should be able to run 2600 rpm or so and stabilize under 230
degrees on my Renesis, but it is not happening.
I am hoping that it will cool when air is moving in flight, but I assume
that if I don’t meet the basic cooling requirement, it will not cool in
flight either.
I am wondering what others are getting for static cooling?
Bill B
From: Rotary motors in aircraft
[mailto:flyrotary@lancaironline.net] On
Behalf Of Al Gietzen
Sent: Monday, May 05, 2008 8:18 PM
To: Rotary
motors in aircraft
Subject: [FlyRotary] Re: Cooling system
changes- Velocity 20B
I thought it was a bit of a mystery that
now that I am dumping heat from the oil/water heat exchanger to the coolant,
the coolant temp is lower, even with the thermostat to the second radiator
closed (yes, there are some small holes in the thermostat, but it’s a
tiny flow area - 0.02 sq. in.). It finally occurred to me that the second
radiator, being very ineffectual as it was, was basically a bypass of the
effective radiator in the cowl. Now that it is blocked by the thermostat,
the increased flow through the effective radiator is lowering the coolant temp.
In effect, this says that the 460 cu. in
of rad core volume is adequate for cooling my 20B, even when dumping some oil
heat load into it. It’s in the neighborhood of 2.3 cu. in. per hp
out. Shows you what an effective scoop and diffuser can do.
Al
-----Original Message-----
From: Rotary
motors in aircraft [mailto:flyrotary@lancaironline.net] On Behalf Of Lehanover@aol.com
Sent: Tuesday, April 29, 2008
12:46 PM
To: Rotary
motors in aircraft
Subject: [FlyRotary] Re: Cooling system
changes- Velocity 20B
In a message dated 4/29/2008
12:50:27 PM Pacific Daylight Time, ALVentures@cox.net writes:
I
drilled three 5/32” holes in the thermostat to keep some flow going
through not thinking that would provide any significant cooling, but I guess it
does. First step is to replace the thermostat; then see if it might be
appropriate to reduce the airflow into the in-cowl rad – in some way that
reduces drag. But the nice thing is there is no urgency – and my
flight regime is not limited.
I use a 180 degree thermostat with a
single 1/8" hole to allow air to escape. On cold days the engine runs
under 180 on yellow laps. That 1/8" hole is enough flow to cool the
engine.
For best power, 160 degrees on the
oil is as high as you need.
Need a
new ride? Check out the largest site for U.S. used car listings at AOL Autos.