I’ve been
considering dissing the OMP and going to premix. My engine is currently off the
plane for plumbing changes (oil/water xchanger install) and rework of wing-root
radiator air inlet. This may be a good time. Is it as simple as removing
the OMP, blanking it off with a plate, and closing the ports in the housing
nozzles with JB Weld?
Al
-----Original Message-----
From: Rotary motors in aircraft
[mailto:flyrotary@lancaironline.net] On
Behalf Of Lehanover@aol.com
Sent: Tuesday, March 25, 2008 7:18
AM
To: Rotary motors in aircraft
Subject: [FlyRotary] Re: Using OMP
rotor housing only
The
engine will run for some time with the OMP not doing anything. Some of my
gifted engines have had the hoses broken off. There will be a slight amount of
oil added from the oil scrapers on the rotor sides not being perfect. The
scrapers will also scrape off unburned fuel and mix it with the crankcase
oil. High oil temps will remove most of that fuel through the breather. Note
that crankcase breather gases are explosive. A good reason to smell the
dipstick when ever it is out.
So, as
the engine wears out the scrapers it starts needing less top oil.
The
only downside to injecting into the housings is poor distribution. It leaves a
boat wake looking stain on the chrome. So, it looks to me like some of that
microscopic amount of oil is discarded without helping anyone. It seems to me
that the best case is the premix. If I were to use the OMP, I would drop it all
in behind the Throttle Body, or into each throat on a carb. Or if you are a
purist, into the float bowl.
Years
ago synthetic crank case oil was specifically not recommended by Mazda.
(because of gumming)
In a
message dated 3/25/2008 10:43:57 A.M. Eastern Daylight Time, ALVentures@cox.net
writes:
So
it would also seem to me that using the OMP with 2-cycle oil in this scenario
is significantly different than pre-mix. But is it as effective, more
effective, or worse??