Due to a break-up and entering the dating world again I have not been as
focused on my project as of late :-).  However, I have been back in the
hangar again now that my schedule has somewhat normalized.

I am having a problem, still, with my EM2.  The coolant temp and  oil temp
is reading "zero" (0).  I have checked the wires, re-wired the connections
and tried them on different sensors all to no avail.

This is really slowing down my engine development as, even though I can run
my engine, I hesitate running it for more than a couple of minutes without
this info for fear of over heating and causing harm.  I did buy an external
infrared gage to help, but still does not solve the problem.

I did mess with the calibration feature on coolant temp with now success.  I
have now re-set those variables to the numbers listed in the RWS EM2 manual.
I still have the zero's staring at me stubbornly.  There is not change from
zero regardless of the temps.

The suggestions that were made this summer were tried, but feel free to
RE-suggest to bring my memory back on-line.  I am becoming annoyed.....both
at the systems and my inability to figure it out. Y'all's help is
appreciated.

All the best,

Chris


Christopher Barber
Attorney and Counselor at Law
5116 Bissonnet, No 418
Bellaire, Texas 77401

Serving the Needs of Senior Texans through
Planning with Purpose

281-464-LAWS (5297)
281-754-4168 Fax
www.TexasAttorney.net