Received-SPF: none
 receiver=logan.com; client-ip=206.190.48.234; envelope-from=squiggles@yahoo.com
DomainKey-Signature: a=rsa-sha1; q=dns; c=nofws;
  s=s1024; d=yahoo.com;
  h=X-YMail-OSG:Received:X-Mailer:Date:From:Subject:To:MIME-Version:Content-Type:Content-Transfer-Encoding:Message-ID;
  b=k0WV314F6a71BARkQEXvjJ/qyVRHhQnmmGjpDvdIf/xK47pUHPpnnBSDzlB9e3ftfQDdpKhP54NuRDEw2+Hly9x7l3s/Vs9w//8IeiSBYPSa0x4lf6I5rzht31R07uq3A8K8BH2NXq1y+GRoYcM6H+B6ehEhcWrW2Fb1c6+1avg=;
Date: Wed, 22 Aug 2007 09:56:49 -0700 (PDT)
From: Scott <squiggles@yahoo.com>
Subject: re: tap 'em holes
To: "flyrotary@lancaironline.net" <flyrotary@lancaironline.net>
MIME-Version: 1.0
Content-Type: text/plain; charset=us-ascii
Content-Transfer-Encoding: quoted-printable
Message-ID: <717217.88228.qm@web52711.mail.re2.yahoo.com>

taping sounds like the best idea...
thx for the help...

as for attaching, the opposite end piece is also counter sunk with a hole s=
aw and is presently held on only jb weld cotton flox mixture.  i've tried t=
o physically push it off, only to hear the wheel chocks sliding on the floo=
r.  short of a hammer blow I doubt it will come off.  which is inline with =
my experience with jb weld.  eventually i'll connect the throttle body and =
rear plate with a threaded rod.  but this does raise the subject of attachi=
ng the forward throttle body plate. yes I could tig it or use the hts2000 b=
razing rods. but i'm leaning towards sinking the hole saw further into the =
plate, roughing up the surface with a file and 40 grit, then using the same=
 jb weld flox slurry.  then using the 2 threaded rods as backup.

If the group is of the opinion jb weld is not strong enough, what epoxy glu=
e would you use? =0A=0A=0A       =0A_______________________________________=
_____________________________________________=0AGot a little couch potato? =
=0ACheck out fun summer activities for kids.=0Ahttp://search.yahoo.com/sear=
ch?fr=3Doni_on_mail&p=3Dsummer+activities+for+kids&cs=3Dbz