Ed,
I would like to clarify another
point and that is your velocity figure of 120 mph.
I will explain:-
I have studied carb sites for
snippets of information ( they don't give much away), however one did
say that carb choke speeds are usually 450' per second and
racing cars 125' per second.
I assume the racing car inlet speeds are
lower because the throttle is wide open with massive sized inlets,
therefore lower vacuum signal.
Your calculations use 176' per second.
Can you clarify where you acquired that figure from as a higher figure
would reduce the inlet area calculations.
The carb I am looking at is the
Revmaster, they currently only have 40mm carbs available due to slow
demand of the 42/44mm. One good thing is that the carb operates
without a need of venturi, however the vacuum signal must be
weaker ( because of this)coupled with a weaker signal because of the
shape of the rotor face.
At the very least the lack of venturi
also eliminates the choke potential. Some carbs have a 44mm inlet but
are choked to 36mm which would increase inlet speed (good), but as you
say, may move into the choke restriction area (bad).
A weaker signal would also effect the
idle mixture as this is driven by vacuum rather than air flow, however
I guess this can be adjusted manually. Should be plenty of vacuum at
idle with the slide closed.
I have asked Revmaster for air flow and
velocity figures, but these may be derived from piston engine type
figures.
If you or Lynn could comment on this it
would be greatly appreciated.
Also my research indicates that flow air/
fuel mix richens at higher RPM and altitude. I can't remember why
at higher RPM - mind block, however for altitude it is because
fuel flow is driven by air flow and even though the density of
the air is lower ( at altitude) the flow remains the same - therefore
richer mixture. Revmaster says their needle design is self leaning (
to a degree) because of design. I assume because the air density
directly affects the suction to the rear side of the flat ground
needle, ( this provides the low pressure area rather than the
venturi) therefore with reduced density you have reduced suction
and reduced fuel and leaner mixture. However I will clarify that
when next we talk.
I find this all very
interesting!
George ( down under)
Well I'll be Ed,
2.4137sq" = (.877x.877xPi = 2.416),
therefore .877 Radius or 1.754 Dia or 44.55 mm for the carb
opening.
I'm working on the rest!
George ( down under)
For inlet, you take the CFM and you need one
other factor - what velocity do you want through your inlet?
Lets say you want a higher velocity of around 176 feet/sec (120
MPH) then we know that Volume = Area * length. If were
want 176 feet/sec velocity from 176 CFM air flow then coverting CFM to
cubic feet per second were have 176Ft^3/min / 60 Second/Minute =
29.333 Ft^3/
Second