|
|
Hi George,
The BD-4 is kind of like that too. There are a few custom items that
are hard to get, the main one being the wing spars. Jim Bede and Team
Aviation are two current sources and there are a lot of old BD-4 kits
around that were never finished. I looked at a kit that had very
little work done on it. The whole kit was $5600 with a lot of
expensive options. If you want high performance at a bargain price,
you can't beat the BD-4. One of my main goals was to have a fast cross country plane. Most of
the big airshows where you can show off a rotary engine are quite a
ways from here. :)
Bob W.
On Thu, 17 May 2007 11:40:06 +1000
"George Lendich" <lendich@optusnet.com.au> wrote:
Bob,
There is a plane that you can build that will cost you 9/10's of sweet bugger all - however it plans built.
The beauty of this plane (Vision) is that you can make parts as you can afford them.
I guess you already have instruments, engine etc.
Worth some consideration.
I'm working on a single rotary for the Light Sport Category (Vision).
Power requirements are between 115 and 125hp.
George ( down under)
--
N93BD - Rotary Powered BD-4 - http://www.bob-white.com
3.8 Hours Total Time and holding
Cables for your rotary installation - http://www.roblinphoto.com/shop/
|
|