Had not thought of that source, Sandy.  A cookie sheet might be just the thing.

Thanks again

Ed
----- Original Message ----- From: "Sandy" <mldsub@earthlink.net>
To: "Rotary motors in aircraft" <flyrotary@lancaironline.net>
Sent: Saturday, February 24, 2007 3:07 AM
Subject: [FlyRotary] Re: Cooked Board - Really!


They also make cookie sheets and baking pans out of it.
You might be able to get it at Wal-Mart for a couple of bucks
if you need more.
--Sandy

-----Original Message-----
From: Rotary motors in aircraft [mailto:flyrotary@lancaironline.net] On
Behalf Of Ed Anderson
Sent: Friday, February 23, 2007 8:14 PM
To: Rotary motors in aircraft
Subject: [FlyRotary] Re: Cooked Board - Really!

Good suggestion, I happen to have some.

Thanks Sandy

Ed

----- Original Message ----- From: "Sandy" <mldsub@earthlink.net>
To: "Rotary motors in aircraft" <flyrotary@lancaironline.net>
Sent: Friday, February 23, 2007 7:55 PM
Subject: [FlyRotary] Re: Cooked Board - Really!


Maybe McMaster-Carr part #8525T41.
--Sandy

-----Original Message-----
From: Rotary motors in aircraft [mailto:flyrotary@lancaironline.net] On
Behalf Of Ed Anderson
Sent: Friday, February 23, 2007 4:10 PM
To: Rotary motors in aircraft
Subject: [FlyRotary] Re: Cooked Board - Really!

Neat Idea, Ernest

Might be less work than trying to develop a manual "pick and Place" gantry
{:>).  I wonder what is easy enough to cut but will withstand 468F for 90
seconds?

Ed
----- Original Message ----- From: "Ernest Christley" <echristley@nc.rr.com>
To: "Rotary motors in aircraft" <flyrotary@lancaironline.net>
Sent: Friday, February 23, 2007 3:11 PM
Subject: [FlyRotary] Re: Cooked Board - Really!

Ed Anderson wrote:

My highly advanced GE convection reflow oven cost $38.99 and that part of

the experiment work perfectly.  Besides, I don't have room for one that
size, Mike {:>)
 The most difficult part of the experiment was placing the components
without rubbing the solder paste off the pad and knocking another
component askew. I now understand why they talked about "arm rests".  It
doesn't take much to get misalign.

Ed, get a second piece of plexiglass cut.  This one to have large holes to

clear the solder pads, but comes in to the thickness of the components.
The idea is to drop the components into a hole that will force them into
alignment.  All the better if it's made of a material that can stand the
heat of the oven.

--         ,|"|"|,              Ernest Christley       |
----===<{{(oQo)}}>===----    Dyke Delta Builder      |
       o|  d  |o        http://ernest.isa-geek.org  |

--
Homepage:  http://www.flyrotary.com/
Archive and UnSub:   http://mail.lancaironline.net/lists/flyrotary/

--
Homepage:  http://www.flyrotary.com/
Archive and UnSub:   http://mail.lancaironline.net/lists/flyrotary/