----- Original Message -----
Sent: Wednesday, December 13, 2006 10:26
AM
Subject: [FlyRotary] One Rotor
The compound side housing, power-take-off end, is
getting ready to be installed and tested. Machining was almost a nightmare,
considered the available means. But, I think it is good enough for the
intended use.
Testing will be for function first, and running
heat cycle second. This is to make sure there is no flaw needing a redesign of
the basic idea.
Once the first tests are successfully completed,
work on the waterpump-side housing will start.
The compound housing as shown in the picture is
15lb. vc 32lb of the stock housing.
Richard Sohn
N2071U
--
Homepage: http://www.flyrotary.com/
Archive and
UnSub:
http://mail.lancaironline.net/lists/flyrotary/