----- Original Message -----
Sent: Friday, December 01, 2006 7:29
PM
Subject: [FlyRotary] Re: gauges
Legally, I don't know - after all, it is
experimental. However, for your own safety, You do need some way to shut
off the fuel - perhaps an electrical activated valve might pass muster.
I do have low pressure fuel lines in my cockpit, but must admit I
am not terribly enthralled about it.
Ed
----- Original Message -----
Sent: Friday, December 01, 2006 7:14
PM
Subject: [FlyRotary] Re: gauges
Speaking of liquids in cockpit, my kit comes with a fuel cut valve
mounted in the cockpit. Am I required to install it? I'm not crazy
about gas in the cockpit with me,but I've been told I must have a fuel cut
valve in the cockpit.
Bob Mears
Supermarine Spitfire
-----Original Message-----
From: eanderson@carolina.rr.com
To:
flyrotary@lancaironline.net
Sent:
Fri, 1 Dec 2006 11:52 AM
Subject: [FlyRotary] Re: gauges
My experience is that the electrical sensor for Oil
temp and pressure are less likely to leak than a capillary tube that is
subject to vibration. I have only used electrical sensors to measure
all engine fluid parameters (except manifold pressure) and have had no
problems. I don't like liquids in the cockpit.
Ed
----- Original Message -----
Sent: Friday, December 01, 2006 12:26
AM
Subject: [FlyRotary] Re: gauges
Group,
Fixing to get oil pressure gauge and am concerned about the quality
of the electrical sending units. How likely are they to leak or come
apart and cause complete oil loss?
Using a mechanical gauge eliminates the sender but uses a capillary
tube that can break. What are the pros and cons to electrical
gauges?
Wendell