|
|
On Sun, 4 Jun 2006 21:02:24 -0400
Bulent Aliev <atlasyts@bellsouth.net> wrote:
On Jun 4, 2006, at 8:30 PM, Scott wrote:
> Hello All...
>
> The attached photo is of my intake. I am now to the
> point of finding a location for the EC2's MAP sensor.
>
> Where have others placed their sensors?
>
> Thx...
>
> -Scott
>
Scott, looks like you can install your MAP port on the 1/4" end plate. Make another 2 ports for temp. sensor and MAP for the fuel pressure regulator. They are 1/8" NPT (Pipe thread)
Hi Scott,
My plenum looks similar to yours. I have one port in the center of the
rear face which I 'T' off to the fuel regulator and the EC2. I
attached my temp sensor to the outside of a cone filter that I'm using
on the throttle body. I don't have a lot of time on the engine yet,
but I believe I'm seeing some variation in the MAP, particularily at
lower RPM. At some point I'm going to try to put a restriction in the
MAP port to see if that will dampen the variation out.
Bob W.
--
http://www.bob-white.com
N93BD - Rotary Powered BD-4 (first engine start 1/7/06)
Custom Cables for your rotary installation -
http://www.roblinphoto.com/shop/
|
|